How do you hang grommet curtains?

Thread the curtain rod through the grommets of each panel. Then hold the curtains rod so the right side of the curtains is facing out. Fasten the curtain to the brackets and screw on the finials to the ends of the curtain rod. Arrange the curtains as desired.

Simply so, can you hang grommet curtains with rings?

They have a clean-lined, simple look that works well in casual and contemporary interiors. You won't need rings, clips or hooks because the hanging hardware is built in, making grommet panels one of the easiest and least expensive curtain types to hang. Measure the width of your window, including any molding.

Secondly, how do you attach eyelets to curtains? Pin the eyelet tape along the top edge of the fabric and sew into place. Draw around the inside of each ring with a fabric pen, then cut out these circles to create the eyelet holes. 3) Press the eyelets into place at the front of the curtain. Fold the bottom 2cm of the panel under and lightly iron.

Also Know, what size rod do you use for grommet curtains?

Sizing. A grommet that is 1/4 inch larger than the rod diameter slides smoothly along the rod. For example, a common 1 5/8-inch grommet glides over a 1 3/8-inch diameter rod.

Where should I hang my 84 inch curtains?

The length of the curtain dictates the height of the rod. If you buy 84-inch-long curtains, the rod must be mounted roughly 84 inches from the floor if the curtains hang from the rod without rings. This lets the hem of the curtains brush the floor.

36 Related Question Answers Found

How do you keep grommet curtains from sliding?

Insert a wood screw into the back of a wooden rod to prevent gathered stationary panels from sliding. Install it toward the center of the rod, at the inside edge of the drapes when they are in the desired open position. Use a 1 1/2-inch screw and leave it extended out from the rod at least 1 inch.

Why do my curtains not hang straight?

Wrap each vertical stack with wide strips of fabric or other soft bindings to keep the folds in place without adding unwanted creases. If you have full-length draperies, bind them in at least three to four places along each column to help set the straight folds. As the fabric cools and dries, the soft folds should set.

Should curtains touch the floor?

The fabric should just touch the floor or hover half an inch above. This is also a great approach for café curtains (short panels that cover only the lower portion of a window and hit the sill), which work well in spots like the kitchen and bathroom, where long drapes aren't practical.

What size grommet do I need?

Grommet and Eyelet Sizing Chart

Size	Outside Diameter (in millimeters)	Inside Diameter (in millimeters)
#0000 (1/8")	8.5mm	3.2mm
#000 (5/32")	7.5mm	4mm
#00 (3/16")	9mm	4.5mm
#0 (1/4")	11.5mm	6mm

Do eyelet curtains look cheap?

One the reasons eyelets are cheaper (and look cheaper) is because they don't use as much fabric, so you lose the cosy fullness of pencil-pleat curtains.

Where should curtain holdbacks be placed?

Generally, curtain tiebacks look best when placed one-third of the way from the top or bottom of the curtain. Tiebacks are both functional and decorative elements of a window treatment. These fabric bands or metal hooks hold the drapes or curtains back from the window.

Are grommet curtains in style?

If your style is modern or trendy, grommet top curtains will complement your décor. The finish of the grommet rings lets the panels slide easily over the rod. Grommets also add strength to the curtain as you handle the material over time. Grommets are made of several materials and contribute to the look of the curtain.

What are the different ways to hang curtains?

There are two ways you can hang your curtains; on a track or on a rod / pole.

Curtain track. A curtain track is an unobtrusive and elegant way to hang curtains, as you don't see the track at all.
Curtain pole.
Rod Pocket.
Curtain rings.
Eyelet.
Tab Top.
Tie Top.
Pencil pleat.

What type of curtains use hooks?

Types of Curtain Hooks

Round pin-on hooks have a rounded top that slides on a cafe or sash rod, allowing pinch-pleated curtains to be used without the standard traverse or rod and rings hardware.
S-hooks are commonly used to hang shower curtains; the top part of the hook goes over the rod and the bottom part fits the grommets in the curtain.

How do you hang curtains with sheer curtains?

How to Install Sheer Curtains Under Drapes

Buy two different curtain rods.
Install the hardware for a curtain rod or a café rod that will be used for the sheer curtains.
Install the drapes' hardware.
Insert the café rod or lightweight curtain rod through the end of the sheer curtain.
Insert the heavier curtain rod into one end of the drapes.

Can you tie back grommet curtains?

After you have them hung, close the curtains to check the length and width before pulling them back open. In most cases, you'll need to use a tie back with grommet curtains. Measure to be sure you install this at the same height on each side of the window frame.

Can I hang regular curtains on a traverse rod?

An intermediate skilled home sewer can utilize drapery maker tricks and successfully hang non–pinch-pleated drapes on a traverse rod, hiding the pins and providing enough support for the weight of the drapes. A traverse rod allows drapes to be opened and closed by pulling on a cord hanging to one side of the drapes.

How do you hang grommet curtains without a rod?

Coat Hooks

To install them, intersperse the coat hooks at an even distance across the window. Loop the holes through each hook to hang your curtains. Coat hooks are easier to hang than traditional curtain rod hardware and don't require drilling.

How can I make my curtains slide easier?

Wax

Remove the curtains from the rod. Remove the rod from the window, if possible, to make it easier to work on.
Rub the stub of a candle over the top of your curtain rod. This deposits a fine layer of candle wax along the top of the rod.

How do you keep grommet panels together?

Grommet panels fall into gentle pleats when in the open position, but each pleat must be adjusted every time the drape is closed. To keep them in place requires a small sleight-of-hand trick from a drapery workroom that allows you to open and close the drapes with the pleats remaining even and adjustment free.

How thick should my curtain rod be?

Choose a curtain rod with a diameter of at least 1 inch (2.5 cm). Thin curtain rods tend to look cheap and can bow under the weight of your drapes if they are heavy. When choosing a curtain rod, look for a rod that is at least 1 inch (2.5 cm) thick for good aesthetics and curtain support.

How much weight can a 5'8 curtain rod hold?

9 lbs per foot and the fluted version only holds 1.5 lbs per foot. This means an 8′ wide window drapery cannot weigh more than 7.2 lbs or 12 lbs.