Can you put siding on an RV?

Asked By: Yandira Montalvoo | Last Updated: 7th April, 2020
Category: travel camping
4/5 (289 Views . 29 Votes)
If you're not a big fan of washing your RV's exterior often, installing fiberglass siding is one of the best RV upgrades you can make. That's because slick, smooth, pristine-white fiberglass doesn't hold onto dirt as well as the matte aluminum your RV might feature.

Click to see full answer


Similarly, it is asked, how is RV siding attached?

The rv siding sheets are installed one at a time from the top down at the factory. The lower edge of each sheet has a "lock" or folded part that allows the sheet to be stapled at the edges and at every vertical stud in the wall.

Similarly, what is the best siding for a camper? If you regularly travel with your camper to areas with inclement weather, fiberglass siding holds up better to hail than aluminum as it resists denting. Laminates on fiberglass are prone to fading and peeling.

In this way, how do you remove siding from an RV?

When it comes to RV siding, there is a really easy technique that you can use to remove it without doing any damage.

  1. Step 1 – Remove Lights. Begin by removing any lights that are installed that may be in the way of the siding.
  2. Step 2 – Remove Staples.
  3. Step 3 – Remove the Siding.

Can you paint the inside walls of an RV?

RV indoor walls are notoriously difficult to paint because the it's really difficult for the primer to adhere to the vinyl 'wallpaper' coating. Because of this, you want to do everything you can to help it adhere properly.

37 Related Question Answers Found

What can I use for RV walls?

Prepare a tape, an 80-grit sandpaper, 60-grit sandpaper, epoxy resin or wood hardener, putty knife and wood putty. Look for water leak sources to prevent more water damage. If the leaks are entering through the windows, apply RV caulking. You can also patch up exterior siding and roof with a waterproof tape.

How thick is RV paneling?

Pre-finished wood paneling is often 1/8" (3/16 and 1/4 thicknesses also available).

Do RV walls have studs?

Besides the thinness of your RV wall, it's very difficult to find where a stud or plumbing might be. Unlike houses where studs have a standard 16” on center interval, the studs in RVs don't have regular intervals. The studs in RVs may not even run vertically--sometimes they're horizontal.

Do campers have studs?


It's worth noting that studs inside a camper are usually spaced irregularly, and sometimes up to 24″ to 36″ apart. They're not like those found in a residential house, on 16″ centers. There may be sections of plywood added in between the studs to reinforce certain areas in your RV's walls.

How much does it cost to reside a camper?

Prices for trailer and RV siding are $8.50 to $11.00 per square foot depending on thickness.

How much does it cost to reskin a camper?

It depends on the size of the camper, but can range anywhere from around $4,000 to $20,000. I'm not sure if this includes labor, but it is very costly to do.

Can you fix delamination on RV?

Once water gets into the substrate behind the fiberglass, then the repair becomes expensive. Stop the cracks early, and you can usually get them repaired before the repairs get pricey. It takes vigilance to keep delamination at bay. The reason is, water intrusions are difficult to spot in their early stages.

How do you replace vinyl trim on RV?

Replace Your RV Insert Trim in 5 Easy Steps
  1. Measure the molding and purchase the correct vinyl trim. First, determine the width of your channel molding.
  2. Remove old insert trim.
  3. Replace new insert trim.
  4. Secure ends of trim.
  5. Seal ends and gaps.
  6. 10 Responses to “How To Replace Exterior RV Weather Molding”

How do you replace one piece of aluminum siding?


How to Replace Aluminum Siding Panels
  1. Using tin snips, make a vertical cut at each end of the damaged piece.
  2. Leave the nailed upper section in place, and remove the lower half.
  3. Cut the nailing tab off the top of the replacement piece.
  4. Spread butyl gutter seal generously along the upper nailed section.

What is Filon?

Filon Flexroof panels are specifically engineered to be a one-piece, laminated roof panel finish for recreational vehicles and campers. Its flexibility allows the panel to bend around the radius where the roof meets the sidewall, resulting in a seamless, no-leak roof system.

How do you fix a hole in aluminum siding in an RV?

Use auto body filler to fill in any large holes. Then, apply your patch with caulking material. For larger holes that affect an entire panel of aluminum siding, it's often easier to replace the sheet rather than attempt to fill in multiple gaps.

How do you fix a dent in aluminum siding?

How to Fix Dents in Aluminum Siding
  1. Screw the #6 self-tapping screw into the center of the dent. You want it where it's deepest.
  2. Use pliers to pull the dent halfway up.
  3. Using sandpaper, take off all the paint.
  4. Fill the dent with the two-part auto body filler.
  5. Sand the patch to remove all roughness and paint it to match the siding.

What are the worst travel trailers?

Worst Travel Trailer Brands According to Reviews
  • Coachmen. Although the Coachmen RV brand is a subsidiary of the Forest River RV Brand, one of the best RV brands around, their recreational vehicles have received a big number of complaints in the past few years.
  • Keystone.
  • Winnebago.
  • Hurricane.
  • Jayco.
  • Fleetwood.

What's better fiberglass or aluminum RV?


If you're looking at your RV as an investment, fiberglass RVs tend to hold their resale value much better than aluminum models. Weight and aerodynamics are two important factors of gas mileage, and fiberglass trailers are generally lighter than aluminum sided campers.

Who makes the best RV trailer?

  • #3. Oliver Legacy Elite 2.
  • #4. Winnebago Industries – Minnie Drop.
  • #5. Happier Camper HC1.
  • #6. Starcraft RV Mossy Oak.
  • #7. Lance Camper 1685 Travel Trailer.
  • #8. Shasta RV 18FQ.
  • #9. Jayco Jay Flight SLX 7.
  • #10. Forest River Alpha Wolf.