Where is the fuse on a Craftsman lawn tractor?

Asked By: Zakiya Quinga | Last Updated: 5th May, 2020
Category: home and garden home appliances
4.4/5 (671 Views . 29 Votes)
Engine would not crank. The fuse is located behind the dash.

Click to see full answer


Also, where is the fuse on a riding lawn mower?

The fuse block location may vary with the age and style of the mower, but is generally located along the wiring harness between the battery and the key switch. On our current style riding mowers, the fuse will either be: A) Under the hood, behind the steering dash panel.

Subsequently, question is, do lawn mowers have fuses? If you think your riding lawn mower has blown a fuse, trying to locate that fuse may be the most challenging step in replacing it. While different lawn mower manufacturers have located the fuse holder in different areas of the lawn mower, the best place to start looking is near the mower's battery, according to Sears.

Herein, where is the fuse on a craftsman lt1000?

The fuse is connected to 2 red wires in the wiring in front of the dash. Sometimes the fuse is under or behind the gas tank and you have to remove the gas tank to find it.

How do you troubleshoot a Craftsman riding lawn mower?

Riding Mower Won't Start A faulty starter, bad spark plug, or clogged carburetor can prevent the engine from starting. Use an ohmmeter to test the starter, and a spark plug tester to test the plugs. If either of these elements are bad, replace them. If the engine still won't start, check the carburetor.

38 Related Question Answers Found

Where is the fuse on my Husqvarna riding mower?

The fuse holder is located under the battery case cover, in front of the battery, in a small holder.

Where is the fuse on a Poulan riding mower?

Fuse is located under the dash, just below the amp meter. Follow the wiring harness, find the wire with the blade fuse. If that isnt the case, load test your battery.

Where is the fuse on an Ariens lawn tractor?

Most tractor models have the fuse tucked under the bracket of the fuel tank or battery (See figures 1 & 2), to shelter it from exposure to the elements, moisture, dirt and debris. There is a clip attached to the bracket that has red wires leading up to it. Pull the clip down to see the fuse.

Why does my riding mower keep blowing fuses?

Most often, the cause of a blown fuse in a riding lawn mower is a short circuit, which happens when a damaged wire or failed component lets electrical current flow to the metal frame of the mower through an unintended path.

Where is safety switch on Craftsman riding mower?


There is a safety switch under the control level that engages the mower blades. I have to lift the level and lower it to be able to start the motor sometimes. Also there are safety switches at brake pedal and of course under the seat.

Where is the fuse on a Cub Cadet?

The fuse block location may vary with the age and style of the mower, but is generally located along the wiring harness between the battery and the key switch. On our current style riding mowers, the fuse will either be: A) Under the hood, behind the steering dash panel.

How do you check a lawn tractor battery?

  1. Lift the seat on your riding lawn mower to access the battery.
  2. Turn on the digital multimeter and switch it to "DC" or "A" to test battery voltage.
  3. Grasp the leads above the finger guards on the probes, and place the red lead on the positive (+) post and the black lead on the negative (-) post on your battery.

Where is the fuse located on a Troy Bilt riding mower?

On our current style riding mowers, the fuse will either be: A) Under the hood, behind the steering dash panel. B) Underneath and behind the battery, located beneath the seat. Note: The battery may need to be removed for access to this fuse block.

What would drain a lawn mower battery?

Lawn mower battery keeps dying
One or more cells in the battery may be dead. Try charging the battery with a battery charger. If the voltage regulator is defective, the battery won't receive enough voltage, causing the battery to drain quickly.

What happens if you put a lawn mower battery backwards?


Usually when the battery is connected backwards, it will short out the charging system. Once started use a meter to check the voltage at the battery. It should be above 12.5 volts dc. If the voltage is dropping, you will need to replace the charging stator.

Where is the fuse on a Troy Bilt Bronco?

Accessing the Fuse
The fuse is installed in the wiring harness, which is near the lawn tractor's battery. Turn off the mower and look beneath the rear fender to find the wiring harness. Pull the fuse out of the wiring harness and inspect it.

What kind of battery does a Craftsman riding mower use?

Craftsman tractors use 12 volt batteries.

How do you troubleshoot a lawn mower?

Your Mower Won't Start:
  1. Loose, Dirty or Disconnected Spark Plug in Your Lawn Mower: Check it out, clean off debris, re-connect and tighten.
  2. Dirty Air Filter: Clean or replace.
  3. Fuel Not Reaching the Engine: Tap the side of the carburetor to help the flow of gas. If this doesn't work, you might need a new fuel filter.

How do you test a solenoid on a riding lawn mower?


First, turn the ignition key to the “On” position. Look for the large terminal posts on the solenoid where the thick red wires connect to the solenoid. Touch the metal shaft of a screwdriver to both of the large terminals at the same time. If the engine turns over and starts, the solenoid is bad and should be replaced.

What size fuse do I need for my amp?

The Right Car Amp Fuse Size
If your amplifier has an internal fuse, then your inline car amp fuse should be a little bit larger. For instance, you might want to use a 25 or 30 amp inline fuse if your amp has an internal 20 amp fuse.

How do I test a fuse with a multimeter?

Before you test a fuse with a multimeter, turn off the equipment and remove the fuse by pulling it straight out of its slot. Turn the meter to ohms, then touch the positive and negative leads together and check the reading. Next, put one lead on each end of the fuse and check the reading.