How many 80lb bags of concrete make a yard?

Asked By: Danya Roose | Last Updated: 7th May, 2020
Category: business and finance construction industry
4.9/5 (13,529 Views . 24 Votes)
How many 80 lb bags of concrete do I need for 1yard? The finished volume of an 80# bag of Sacrete orQuikrete (pre-mixed cement, sand and gravel) is 0.6 cubic foot(stated on the bag). There are 27 cubic feet in a cubicyard. Dividing 27 cubic feet by the volume of the bagwill give you the number of bags you need.

Click to see full answer

Also asked, how many 80lb bags of concrete is a yard?

A 80 lb. bag provides 0.6 cubic feet ofcured concrete. If you have concrete delivered it issold by the yard (which is a cubic yard = 27 cubicfeet).

Furthermore, how many 80lb bags of concrete are on a pallet? SAKRETE 80LB CONCRETE MIX 42 BAGS PERSKID. TWPerry.

Additionally, how much does a 80lb bag of concrete cover?

Quikrete's Concrete Mix yield's about .15 cubicfeet for every 20 pounds of mix, so a 40-pound bag yields.30 cubic feet, 60 pounds of concrete mix yields .45 cubicfeet and an 80-pound bag yields .60 cubic feet. One 50-poundbag of Quikrete Fast Setting Concrete Mix yieldsabout .375 cubic feet.

How many bags of Portland cement are in a yard?

5 Bags

36 Related Question Answers Found

How many 80 pound bags of concrete does it take to make 1 yard?

How many 80 lb bags of concrete do I need for1 yard? The finished volume of an 80# bag ofSacrete or Quikrete (pre-mixed cement, sand and gravel) is0.6 cubic foot (stated on the bag). There are 27 cubic feetin a cubic yard. Dividing 27 cubic feet by the volume of thebag will give you the number of bags youneed.

How many 60 pound bags of cement does it take to make a yard?

Calculating from Volume
Thus, a 3,600-pound cubic yard containsabout 800 pounds of cement, which comes out to 10 ofthe 80-pound bags of cement or 13.3 of the60-pound bags.

How many bags of cement do I need for 1 yard?

# It takes approximately 5 Bags of Portlandcement, 8 cubic ft of sand, and 20 cubic ft of gravel tomake approximately 1 cubic yard (27 cubic feet) ofconcrete.

What is the minimum amount of concrete you can order?

What Is The Minimum Amount of Concrete forDelivery? The minimum concrete delivery for ready-mixconcrete is a truckload of about 10 cubic yards at $119 to$147 per cubic yard. If you order less than 10 cubic yardsof cement, there will be an additional fee ofapproximately $53 per cubic yard.

How many square feet are in a cubic yard?

One Cubic Yard = 27 Cubic Feet Length x Width = SquareFeet
1 YD 4 YD
4 Inches 81 sq.ft. 324 sq.ft.
5 Inches 65 sq.ft. 260 sq.ft.
6 Inches 54 sq.ft. 216 sq.ft.

How much is a yard of cement?

Use $90 per cubic yard as a ballpark figure forconcrete prices, but concrete slab cost will vary byregion. Also, expect a fee of about $60 per load for delivery froma concrete truck for concrete cost. There could be otherfees for such things as Saturday concrete truck delivery and smallloads.

How much is concrete per post?

Estimating 60-lb Bags of Fast-Setting Concrete Mix
3-in Post Diameter / 9-in Hole Diameter 6-in Post Diameter / 18-in Hole Diameter
Hole Depth in Inches Number of Bags needed Per Hole Number of Bags needed Per Hole
10 1 3
12 1 4
14 1 4

How much is a load of concrete?

Each cubic yard costs about $65. However, a fully loadedcement truck will hold 10 cubic yards—and partial“short” loads cost $15 to $20 extra for everycubic yard less than a full load.

How many bags of concrete do I need for a 10x10 slab?

Enter the size of the slab you want to build insquare feet. The calculator will indicate the number of 60 or 80pound bags of QUIKRETE® Concrete Mix youneed to build a 4″ or a 6″ slab. (Allyields are approximate and do not include allowance foruneven subgrade, waste, etc.)

How fast does quikrete set?

Quikrete Fast Setting Concrete Mix is a specialblend of fast-setting cements, sand and graveldesigned to set hard in approximately 20 - 40minutes.

How thick should a concrete patio be?

If they don't, then 4" thick is usually standardfor a patio slab, how large or small it is doesn't reallymatter. The most important part is the sub-base. Make sure you havea good gravel base. I would recommend at least 12 inches ofcompacted gravel.

Is concrete expensive or cheap?

Cost. Ignoring any maintenance costs, asphalt isgenerally much cheaper to install than concrete. Onaverage, the cost per square foot for asphalt will runbetween $2.50 to $4.00. It's not unheard of to have a stainedconcrete driveway with a smooth finish cost over$15.00 per square foot.

How do you make cement?

To make concrete though which will greatly extendthe volume produced you mix in gravel or sand or crushed brick.Proportions are an endless subject of debate but the formula of 1part cement, 2 parts sand and 3 parts gravel by volume is agood starting point. Mix the dry ingredients first and then slowlyadd water.

How do you set a 4x4 post?

Project Instructions
  1. Dig post hole so diameter of the hole is 3 times the width ofthe post (i.e., the hole for a 4” wood post should be about12 inches wide).
  2. Add about 6 inches of QUIKRETE All-Purpose Gravel into thebottom of the hole.
  3. Set the post into the hole and attach 2x4 braces to adjacentsides of the post.

What is quikrete?

Quikrete 80 lb. Concrete Mix can be used forbuilding or repairing foundation walls, sidewalks, curbs, steps andramps and for setting posts. This mix designed for pouring concrete2 in. thick or more. Concrete Mix consists of a uniformly blended,properly proportioned mixture of gravel, sand and Portlandcement.

How much water do you put in a 60 pound bag of quikrete?

For each 80 lb (36.3 kg) bag ofQUIKRETE® Concrete Mix to be mixed, addapproximately 6 pt (2.8 L) of fresh water to themixer.

What is 5000 psi concrete used for?

Typically, reinforced concrete ranging between3,500 to 4,000 psi is used on footing and slabs ongrade; between 3,500 to 5,000 psi on suspended slabs, beamsand girders; and walls and columns normally require between 3,000to 5,000 psi. When non-reinforced concrete isused different strengths will be required.