How do you make a portable wood step by step?

Asked By: Ayesha Roeloff | Last Updated: 2nd January, 2020
Category: hobbies and interests woodworking
4.9/5 (10 Views . 13 Votes)
How to Build Portable Wooden Steps
  1. Measure the width and height of the location where steps are needed.
  2. Cut two sections of the 2-by-4 into 36-inch pieces with 45-degree cuts at each end.
  3. Measure your height to the top of the stringers, and cut your upright posts from the 4-by-4 treated lumber six inches higher than your measurement.

Click to see full answer

Subsequently, one may also ask, how do you make a portable wooden step?

How to Build Portable Wooden Steps

  1. Measure the width and height of the location where steps are needed.
  2. Cut two sections of the 2-by-4 into 36-inch pieces with 45-degree cuts at each end.
  3. Measure your height to the top of the stringers, and cut your upright posts from the 4-by-4 treated lumber six inches higher than your measurement.

Similarly, how do you make a garden step by step? Fill the first riser with gravel and top it with a layer of fine concrete. Next build the other risers and the perimeter wall until the outline of the flight is complete and backfill behind the risers. Layer the slabs forming the steps and tamp them down. Check to see if it is level, by using a spirit level.

Keeping this in view, how do you make easy steps?

Steps

  1. Measure the height of the area where you will install the stairs.
  2. Divide the total rise by the typical rise per step.
  3. Divide the total rise by the number of steps to get the actual rise per step.
  4. Establish the run of each step.
  5. Find the total run of the staircase.
  6. Decide if your stairs need landings.

What are the steps to making a dog?

Steps

  1. Cut the Parts. Using a miter saw and the cut list above, cut the 1×2 and 1×6 pieces to size.
  2. Cut the Sides. Using a circular saw cut along the line on each plywood Side.
  3. Place the First Cleat.
  4. Layout the Cleats.
  5. Install the Cleats.
  6. Finish Installing the Cleats.
  7. Attach the First Riser.
  8. Attach the Remaining Risers.

22 Related Question Answers Found

What are the steps to make a spa?

Lastly, you will need 4 pieces of 2×4 cut for the treads.
  1. Cut the stringers to the width you want the hot tub step to be.
  2. Next cut the 4 pieces for your sides.
  3. Lastly, cut your treads to the same length as your stringers plus 5″
  4. Build two boxes using wood screws and wood glue, and stack them like in the picture above.