How do I widen my concrete driveway?

Category: home and garden landscaping
4.7/5 (32 Views . 12 Votes)
How to Extend Your Driveway With Concrete
  1. Dig the soil to a depth of at least 5 inches where you want to pour the extension.
  2. Build your concrete forms with 2-inch-by-4-inch dimensional lumber to the desired length and width of the extension.
  3. Level the top board of your forms with a transit or a long carpenter's level.



Accordingly, how can I make my concrete driveway wider?

How to Extend Your Driveway With Concrete

  1. Dig the soil to a depth of at least 5 inches where you want to pour the extension.
  2. Build your concrete forms with 2-inch-by-4-inch dimensional lumber to the desired length and width of the extension.
  3. Level the top board of your forms with a transit or a long carpenter's level.

Subsequently, question is, how much does it cost to widen a driveway? For an average two-car concrete driveway that is 20 feet wide and 30 feet long (600 sq. ft.) without slopes or curves costs $3,266.

Concrete Driveway Cost.
National Average Cost $3,266
Minimum Cost $1,800
Maximum Cost $8,500
Average Range $2,214 to $6,110

Then, how do I widen my driveway?

DIY: Driveway Widening

  1. Lay ropes along the side of the driveway you want to expand.
  2. Use a spade and trenching hoe to remove growth and 12 inches of topsoil from the land within the ropes.
  3. Tamp the subbase several times with a hand tamper until it resists pressure.
  4. Fill the site with 8 inches of 3/4-inch aggregate and tamp it down.

Can you concrete your own driveway?

Good Reasons Not to Pour Your Own Concrete Driveway The curing concrete waits for no one, and it's usually difficult or impossible to fix mistakes. If that doesn't scare you away from a large project like a driveway, then you should consider the skill required to finish concrete correctly.

31 Related Question Answers Found

How can I make my own concrete driveway?

Part 3 Pouring and Curing the Concrete
  1. Pour the concrete from the truck or wheelbarrow.
  2. Flatten and level the slab as desired.
  3. Put in contraction joints about 1 inch (2.5 cm) deep.
  4. Use a brook or sack to add texture to the concrete.
  5. Cure the concrete.
  6. Park your car on your new driveway.

Can you pour a driveway with bagged concrete?

Quikrete recommends its Quikrete 5000 concrete mix for driveway use, with coverage of . 6 cubic feet per 80-pound bag. For a driveway foundation 20 feet long, 10 feet wide and 4 inches in depth, the volume of the driveway is 66 cubic feet.

How thick is concrete driveway?

As for thickness, non-reinforced pavement four inches thick is standard for passenger car driveways. For heavier vehicles, a thickness of five inches is recommended. To eliminate standing water, the driveway should be sloped towards the street a minimum of one percent, or 1/8 inch per foot, for proper drainage.

Can you lay concrete on concrete?

Yes, you may pour a concrete pad overlay over an existing slab. You need to consider the added height and weight of the overlay on the existing structure. Overlays may include polymers, portland cement concrete, or epoxies. You should improve the drainage of the slab by having a good slope on the overlay.

How long till I can drive on my new concrete driveway?


Your new concrete is designed to reach 90% of its full strength potential after 7 days, so feel free to drive your personal vehicle on it then. It will take additional time before you can drive or park heavy equipment or machinery on your newly poured concrete, so make sure to wait at least 30 days.

How much is a paved driveway?

The average cost of a concrete driveway, by comparison, is almost $7,400. Other sources estimate the cost to install an asphalt driveway to be between $2,300 and $10,300. Homeowners typically pay per square foot. Reibling adds the average cost per square foot is between $3.50 and $4.50.

Do you need planning permission to widen a driveway?

You will not need planning permission if a new or replacement driveway of any size uses permeable (or porous) surfacing which allows water to drain through, such as gravel, permeable concrete block paving or porous asphalt, or if the rainwater is directed to a lawn or border to drain naturally.

How do you widen a brick driveway?

How to Extend a Driveway With Pavers
  1. Measure the height of the concrete pavers.
  2. Dig out the driveway extension area to the depth indicated by your measurements.
  3. Spread 6 inches of crushed rock over the dug-out area.
  4. Lay plastic edge restraints along the perimeter of the paver area, setting them on top of the rock base.

What is the apron of a driveway?

A driveway apron is the section where a private driveway connects to the public roadway; it is usually the width of the driveway and about 8'-15' long (extending from the curb to the far edge of the sidewalk, or to the property line), although some decorative aprons can be 60'-70' or longer.

Does a new concrete driveway increase home value?


Concrete can easily crack in the winter time. Asphalt is more flexible making it less likely to crack over time. Asphalt driveways can last you 20-25 years if properly installed and maintained – a great investment. While they increase the value of your home, a nice paved driveway can also help sell your home FASTER.

Does a concrete driveway increase home value?

Increase the value. In addition to having a house which is more sellable because of the garage, having this will only add value to your property. Adding a driveway to your property can add up to 10% to the value.

What is the cheapest driveway material?

Pound for pound, aggregate is the cheapest of these four common driveway materials. A basic gravel driveway can cost as little as $0.50 per square foot – an order of magnitude less than a professionally installed asphalt, stone, or concrete driveway. Durability. Aggregate is extremely durable.

Does a double driveway add value?

It's estimated that having an attractive driveway to compliment your home can add up to 10% of your property's value, according to Virgin Money.

Is it cheaper to pave or concrete a driveway?

Cost. The cost of an asphalt driveway is typically cheaper than concrete, costing $2.00 – $4.00 per square foot. In contrast, a concrete driveway costs between $4.00 – $6.00 per square foot for a standard installation. Finishes, details and stains can increase the price tag to as much as $15.00 per square foot.

How much is a new concrete driveway?


The national average cost to install a concrete driveway is about $6 a square foot. According to Joe Pilson, owner of Complete Concrete in Denver, Colorado, a typical driveway big enough for one car and room to turn around is about 500 square feet, with an average total project cost of $3000.

Can I make my front garden a driveway?

Once you have obtained permission for your crossover — or after your council has confirmed such permission isn't necessary — you can convert your front garden into a driveway under permitted development rules, subject to certain conditions.

Is rebar needed in concrete driveway?

Rebar can be required if the soils behave poorly, the slab is large and flatness/cracking are design issues… but that is a very unlikely scenario. Rebar is best utilized in a driveway for which 5-6 inches of concrete can be poured. This is because rebar is relatively thicker than galvanized mesh reinforcement.