Why is my grinder pump so loud?

Asked By: Nelba Roloff | Last Updated: 11th April, 2020
Category: home and garden home appliances
4.5/5 (253 Views . 43 Votes)
Answer - This is a fairly common problem with sewage ejector pumps. The noise is caused by the closing of the check valve. A check valve is one that allows flow in only one direction. It is used with ejector systems to prevent backflow of sewage into the basin after each pumping cycle.

Click to see full answer

Then, are grinder pumps noisy?

Frozen pump: Your grinder pump is buried down in the ground at a level below the frost line to prevent it from freezing during our chilly winters. The pump will start to work slower or make loud noises. Plumbers will need to clear out the clotting before the pump breaks down.

Furthermore, how long should a grinder pump last? 10 years

Likewise, people ask, how often should a grinder pump run?

Grinder pumps do not need to be pumped out because they pump out the wastewater once the contents reach a certain level. Grinder pumps average eight years between service calls, so minimal regular maintenance is required when operated under normal conditions.

Why is my grinder pump alarm going off?

A: No, the grinder pump requires electricity to run. When the power comes on again, the alarm may go off for a short time – this is normal because the water could be above the pump's alarm level and the pump needs a few minutes to pump down the tank to a normal level. If the alarm does not turn off, call for service.

35 Related Question Answers Found

What happens when a grinder pump fails?

When the grinder pump fails, an alarm will be triggered to go off on your septic systems alarm panel. Another thing that can happen if your grinder pump fails is that your tank could overflow into your backyard, or back up into your home through sinks and toilets.

How do I turn off my grinder pump alarm?

Turn off the alarm by depressing the alarm light on the front of the alarm box. if your system is publically owned. This number is also listed on your alarm box. If your grinder pump system is privately owned, you will need to contact a licensed plumber or the supplier of the pump to resolve the problem.

Do grinder pumps smell?

When property owners complain they have sewer gas smells by a sewage ejector or grinder in the basement or by their pump tank, you should take that complaint seriously. Hydrogen sulfide is dangerous even at low levels. Even if the smell comes and goes, it needs to be addressed.

How do you know if you have a grinder pump?

Grinder pump trouble!
Early warning signs that this has happened include multiple clogged drains and toilets in the house and foul odors coming from drains. These could also be from other sewer line issues, but no matter what, they need to have a professional plumber look into them right away.

What is a poop grinder?

A grinder pump is a wastewater conveyance device. Once the wastewater inside the tank reaches a specific level, the pump will turn on, grind the waste into a fine slurry, and pump it to the central sewer system or septic tank. Grinder pumps can be installed in the basement or in the yard.

How do you change a grinder pump?

If your pump fails, you will need to replace it as quickly as possible, which may mean doing it yourself instead of calling a professional.
  1. Locate Your Grinder Pump.
  2. Purchase the Replacement Pump.
  3. Disconnect the Electricity.
  4. Remove the Old Pump.
  5. Install the New Alarm System.
  6. Install the New Pump.

How much does it cost to replace a grinder pump?

There is a huge difference in the replacement cost of the grinder pumps, which can have a $2,000.00 to $3,000.00 retail price depending upon installation and labor. The replacement cost of a sewage pump could be in the $400.00 to $600.00 price range depending upon installation and labor.

What can you not put in a grinder pump?

There are electrical cables buried beneath the ground and pressurized sewer pipe. napkins or tampons; Condoms; Diapers, Paints or paint thinner; socks, rags, cloth or baby wipes; Kitty litter; Cooking grease, oils, or fats.

Why does my grinder pump keep running?

The most common cause of a sump pump system running continuously is when the sump pump float switch is stuck on the "on" position in your sump pit. This will cause it to run even when all water has been removed, which will burn out the pump prematurely.

Can a grinder pump handle tampons?

A sewage grinder pump can easily handle 2 inch solids, and will also be able to handle difficult artificial solids, like feminine hygiene products (pads, tampons, etc), rags, towels, diapers, diaper wipes, napkins, underwear, and a range of other things that shouldn't be flushed down toilets but often are.

What is the difference between a sewage pump and a grinder pump?

Sewage Grinder pumps have cutting blades that grind the raw sewage into a slurry before passing it through the discharge line. Sewage Grinder Pumps are designed to handle the same type of materials as a Sewage Ejector Pump, but have the ability to pass tougher solids.

Is it good to buy a house with a sump pump?

A sump pump can be a great addition to any house, but if you're buying a home, the property you're interested in may already come with one. Although you may have heard about the negatives of having a sump pump, depending on the type of home you have, they can be an excellent tool in case of flooding.

Can you use a garbage disposal with a grinder pump?

When a residence is at a lower elevation than the sewer main, it requires the use of a pump to force the wastewater up to the gravity sewer main. A grinder pump works like a garbage disposal – it grinds up wastewater from a home (i.e. toilet, shower, washing machine) and pumps it into the public sewer system.

Do sewage ejector pumps smell?

It's not normal for there to be a sewage odor coming out of a condensate pump and into occupied space.

What size septic pump do I need?

Suction/discharge sizes will sometimes be listed on the casing. The average size for waste solids in residential systems is 1 ½” or larger. For commercial or industrial systems, the average solids size is 2 ½” or larger. Flow and total dynamic head (TDH) are integral in selecting a pump.

How does a grinder pump system work?

When water is used in the house, wastewater flows into the tank. When the wastewater in the tank reaches a pre-set level, the grinder pump automatically turns on, grinds the waste, and pumps it out of the tank via the homeowner's on-site sewer service line and into the public sewer system.

What is a grinder pump cost?

A grinder pump is a pumping unit consisting of a pump and small pipe from the unit to the sewer system. The average cost for installing the grinder pump is approximately $4,000-$5,000, but varies per property.