Where is the water pump located on a 2008 Chevy Impala?

The 2008 Chevrolet Impala base model came with a 3.5-liter engine and an automatic transmission. The water pump is mounted on the right side of the engine and is driven by the accessory drive belt. When you replace the water pump, you will reuse its pulley on the new water pump.

Also to know is, how much is a water pump for a 2008 Chevy Impala?

The average cost for a Chevrolet Impala water pump replacement is between $249 and $499. Labor costs are estimated between $126 and $160 while parts are priced between $123 and $339. Estimate does not include taxes and fees.

Likewise, when should you replace a water pump? However, mechanics often replace water pumps before they fail. Beckwith says many shops recommend replacing the water pump while simultaneously making other labor-intensive repairs, such as swapping out the timing belt. A water pump should last 60,000 to 90,000 miles, about the same amount of time as a timing belt.

Beside this, how do I change a water pump?

How to Remove a Car Water Pump

Turn off the car engine.
Let the engine cool down.
Open the valve on the bottom of the radiator and drain the water from the system.
Loosen the alternator from its mounting brackets.
Remove the drive belts that are attached to the water pump.
Loosen the water pump from its mounts and remove the engine pulley fans.

How much is a water pump for a 2007 Impala?

Or you may just be struggling to keep it highway-approved. No matter the situation, Advance Auto Parts has the Water Pump product you desperately need. We currently carry 7 Water Pump products to choose from for your 2007 Chevrolet Impala, and our inventory prices range from as little as $53.46 up to $601.88.

23 Related Question Answers Found

How do I know when my water pump is bad?

Here are some common symptoms that hint towards having a bad water pump:

Coolant leak at the front-center of your car.
Water pump pulley is loose and making whining sounds.
Engine is overheating.
Steam coming from your radiator.

Can a bad water pump cause rough idle?

Rough idle can be caused by water pump

Needed a tow to the dealer. Explanation is that bad water pump bearing create a noise that is detected by the knock sensor. Timing is varied, causing roughness.

What does a water pump do?

The water pump pushes coolant from the radiator through the coolant system, into the engine and back around to the radiator. The heat that the coolant picked up from the engine is transferred to the air at the radiator. Without the water pump, the coolant just sits in the system.

Where is the fuel pump located on a 2012 Chevy Impala?

If your model Impala is a LS, which I believe this applies to all models that year, the fuel pump is located in the engine compartment on the drivers side closest for the radiator end of the block. You can remove the fuel shroud shield on the top and access the fuel tails that need to be removed.

Can you drive a car with a bad water pump?

Hey there, To answer your first question, yes, it is very possible to drive a car without a water pump. If you plan on keeping your car, then you definitely need to have a new water pump installed, flush out the coolant system, and make sure all the coolant hoses are clean and free of holes.

What does a bad water pump sound like?

A more likely failure of your engine's water pump is a bearing failure. A worn bearing in your water pump will usually manifest itself as pump noise as it will allow the pump pulley to wobble as it rotates. In extreme cases, you may be able to see the pump pulley or belt wobbling as your engine idles.

What else can replace a water pump?

The most common related services accompanying water pump replacement are cooling system flush, testing the radiator cap, and possibly flow testing of your radiator to make sure that the radiator is not clogged.

Can a bad water pump drain your battery?

Symptoms of a Failing Water Pump in Your Car. There are a lot of things that can go wrong with your car. Your engine can overheat or break down, and the battery could die. You don't get this type of luxury for other things that go south with your car; one such problem is a failing water pump.

Do you have to drain the coolant when changing a water pump?

Yes the first thing the mechanic will do when when changing the water pump is drain the old coolant! As in he will open the drain plug and drain it out and throw away the old stuff. And then when he put it all back together he will add coolant and water and the coolant should be new.

How long should a water pump last in a car?

The service life of most original equipment water pumps should be 100,000 miles or longer. Some cheap replacement water pumps, however, may not last 30,000 miles before they start to leak. That's why you should recommend a top-quality replacement water pump if a customer's old water pump has called it quits.

Where is a water pump located?

The pump circulates fluid whenever the engine is running. The water pump uses centrifugal force to send fluid to the outside while it spins, causing fluid to be drawn from the center continuously. The inlet to the pump is located near the center so that fluid returning from the radiator hits the pump vanes.

Where is the water pump located in a house?

Pressure tanks are usually located in a garage, in a closet, near your water softener and water heater, or in colder climates it can be located in the basement.