How do you adjust the headlights on a 2006 Hyundai Sonata?

Locate the adjustment screws on the top and rear of each headlight assembly. Aim the headlight beams so that they hit 10.5 inches to the right of and 5 inches below their corresponding cross mark on the wall. This ensures the headlights do not hit oncoming traffic, while also illuminating street signs.

Simply so, how do you adjust the headlights on a 2007 Hyundai Sonata?

Reverse your Sonata until your headlights line up above the tape. Turn on your headlights and prop open the hood. Look behind each headlight assembly for the two adjustment screws. Twist these with your fingers or a screwdriver to adjust the vertical and lateral aim of the headlights.

Subsequently, question is, how do you change a low beam headlight? Change a Headlight Bulb in 4 Steps

Tools you need:
Step 1: Locate the headlight holder. You'll access your headlight bulb through your engine compartment, rather than from the front of the car.
Step 2: Remove the power wires.
Step 4: Clean and install the new bulb.
Extra: Replacing Tail Light Bulbs.

Likewise, where are the headlight adjustment screws?

Most adjustment screws are located on the top and side of the light housing. They should be clearly marked. If you cannot locate the screws, check your owner's manual. It should be noted that some manufacturers have located the adjustment screws in the engine compartment behind the headlight housing.

How do u clean headlights?

If the headlights are only slightly foggy, you can try and restore them using an abrasive, like toothpaste, and lots of scrubbing. First, clean the headlights with Windex or soap and water. Then, using a soft cloth, rub a fingertip amount of toothpaste onto the wet headlight. (Toothpaste with baking soda works best.)

28 Related Question Answers Found

How do you change a low beam headlight on a Hyundai Sonata?

How to Change the Low Beam Headlight in A Hyundai Sonata

Turn off your Hyundai Sonata and prop open the hood.
Depress the tabs on either side of the wiring harness on the rear of the headlight assembly and pull it off.
Depress the tab on top of the weather cover and pull it free from the headlight assembly.

How high should headlights be at 25 feet?

It's best you measure this out, so the distance is accurate. Not every vehicle requires a 25-foot distance from the wall. This is a general distance with some manufacturers require different distances. Chrysler says 33 feet while Toyota recommends aligning headlights at 10 feet.

How far should your headlights shine while on low beam?

Your headlights only let you see about 350 feet ahead. Be sure you are driving slow enough to stop or turn if needed. Use your low beams when you come within 500 feet (about one block) of an oncoming vehicle. Also use your low beams when following another vehicle within 300 feet.

What is a headlight aiming screen?

Use of a Headlight Aiming Wall Screen

The wall screen is an out dated and extremely time consuming method of aiming headlights. It requires a long, flat, work bay and is simply not practical for the majority of repair shop applications.

How much does it cost to adjust headlights?

The average cost for a headlamp alignment adjust is between $38 and $49. Labor costs are estimated between $38 and $49. Estimate does not include taxes and fees. When would you like to drop off your car?

How do you change the screws on a headlight?

Step 2: Using the screwdriver, turn each screw counterclockwise to loosen them from the headlight assembly. Note this will also change the aim of the headlights. Step 3: Screw in the new adjustment screws. Step 4: Once the replacement headlight adjusting screws are in place, you now have to re-aim your headlights.